D-Link DIR-X1530 User Manual page 204

DIR-X1530 AX1500 Wi-Fi 6 Gigabit Router
User Manual
Parameter
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Set as
LAN: The rule will be applied to the packets transmitted to
•
the local network.
GRE: The rule will be applied to the packets transmitted to
•
the GRE tunnel (available if a GRE tunnel has been created
on the device).
IPIP: The rule will be applied to the packets transmitted to
•
the IPIP tunnel (available if an IPIP tunnel has been created
on the device).
IPsec: The rule will be applied to the packets transmitted to
•
the IPsec tunnel (available if an IPsec tunnel has been
created on the device).
PPTP Server: The rule will be applied to the packets
•
transmitted to the PPTP server (available if a PPTP server
has been created on the device).
L2TP Server: The rule will be applied to the packets
•
transmitted to the L2TP server (available if an L2TP server
has been created on the device).
From the Source interface and Destination interface drop-
down lists, select source and destination interfaces for which the rule
will be applied. Leave the Auto values to apply the rule to all
created WAN interfaces.
Source IP address
Select the needed value from the drop-down list.
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The source host end IPv4 or IPv6 address.
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Destination IP address
Select the needed value from the drop-down list.
Page 204 of 254
Configuring via Web-based Interface
Description