Jumper Settings; Table 5-1. Jumper Switches And Settings - Motorola AltiVec MVME5100 Series Installation & Use Manual

Pin Assignments

Jumper Settings

5
Jumper
J1
J2
J4
J5
J6, J20
J7
J10, J17
J15
J16
5-2
The following table provides information about the jumper settings
associated with th MVME5100 Single Board Computer. The table below
provides a brief description of each jumper and the appropriate setting(s)
for proper board operation.

Table 5-1. Jumper Switches and Settings

Description
Riscwatch Header
Pal Programming Header
Ethernet Port 2 Selection
(set in conjunction with
jumpers J10 and J17)
On-Board Serial Port
(COM2)
Operation Mode
(Set Both Jumpers)
Flash Memory Selection
at Boot
Ethernet Port 2 Selection
(set in conjunction with
jumper J4)
System Controller (VME)
Soldered Flash Protection
Setting
None (Factory Use Only)
None (Lab Use Only)
For "P2" Ethernet Port 2:
Pins 1,2; 3,4; 5,6; 7,8
For "Front Panel" Ethernet Port 2:
No Jumpers Installed
Not Available as of Publication Date
Pins 1,2 for PMC Mode
Pins 2,3 for 761 Mode
Pins 1,2 for Soldered Bank A
Pins 2,3 for Socketed Bank B
For "Front Panel" Ethernet Port 2:
Pins 1,3 and 2,4 on Both Jumpers
For "P2" Ethernet Port 2:
Pins 3,5 and 4,6 on Both Jumpers
Pins 1,2 for No SCON
Pins 2,3 for Auto SCON
No Jumper for ALWAYS SCON
Pins 1,2 Enables Programming of
Flash
Pins 2,3 Disables Programming of Flash
Computer Group Literature Center Web Site
Default
N/A
N/A
No
Jumper
Installed
N/A
PMC
Mode
Socketed
Bank B
Front
Panel
Ethernet
Port 2
Auto
SCON
Flash
Prog.
Enabled