Pmc Modules - Motorola AltiVec MVME5100 Series Installation & Use Manual

Hardware Preparation and Installation
1

PMC Modules

Warning
Caution
1-6
PMC modules mount on top of the MVME5100. Perform the following
steps to install a PMC module and on your MVME5100.
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
1. Inserting or removing modules with power applied may
result in damage to module components.
2. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
Note This procedure assumes that you have read the user's manual that
came with your PMCs.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to an electrical ground. Note that the system chassis may not
be grounded if it is unplugged. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME modules.
3. If the MVME5100 has already been installed in a VMEbus card slot,
carefully remove it as shown in
connectors P1and P2 facing you.
4. Remove the filler plate(s) from the front panel of the MVME5100.
5. Align the PMC module's mating connectors to the MVME5100's
mating connectors.
6. Insert the appropriate number of Phillips screws (typically 4) from
the bottom of the MVME5100 into the standoffs on the PMC
module and tighten the screws (refer to
Figure 1-2 and place it with
Figure 1-3).
Computer Group Literature Center Web Site