Setup; Pressure Relief Procedure; Cup Fill - Graco TrueCoat 360 Owner's Manual

Setup

Pressure Relief Procedure

Follow the Pressure Relief
Procedure whenever you see this
symbol.
This sprayer builds up an internal
pressure of 2000 psi (138 bar, 13.8 MPa)
during use. Follow this Pressure Relief
Procedure whenever you stop spraying
and before cleaning, checking, servicing,
or transporting equipment to prevent
serious injury.
1. Turn Prime Knob down to PRIME position
to relieve pressure.
3A9014A

Cup Fill

Use only water-based or oil-based
(mineral spirit-type) materials with a
flash point greater than 100° F (38° C).
Do not use materials which state
"FLAMMABLE" on the packaging. For
more information about your material,
request a Safety Data Sheet (SDS) from
distributor or retailer.
When spraying oil-based material, use
outdoors or in a well-ventilated indoor
area with a flow of fresh air.
Keep spray area well-ventilated. Keep a
good supply of fresh air moving through
the area.
If spraying oil-based materials, review Fluid
Compatibility, page 21, and follow Static
Grounding Instructions (Oil-Based
Materials), page 21.
1. Insert one FlexLiner into the Cup
Support.
NOTE: Verify there is no damage to the top
sealing edge of the FlexLiner, such as a
crease or fold. If damaged it will leak air and
lose prime.
Setup
11