Spraying; Spray Tip Orientation - Graco TrueCoat 360 Owner's Manual

Spraying

Spraying
Use only water-based or oil-based
(mineral spirit-type) materials with a
flash point greater than 100° F (38° C).
Do not use materials which state
"FLAMMABLE" on the packaging. For
more information about your material,
request a Safety Data Sheet (SDS) from
distributor or retailer.
When spraying oil-based material, use
outdoors or in a well-ventilated indoor
area with a flow of fresh air.
Keep spray area well-ventilated. Keep a
good supply of fresh air moving through
the area.
1. Set the Speed Control to lowest
available setting.
2. Pointing at a piece of scrap cardboard,
pull the Trigger to test the spray pattern.
3. If needed, slowly increase the Speed
Control to the setting that produces a
good spray pattern.
NOTE: To minimize overspray, always spray
at the lowest speed setting that gives a good
spray pattern.
4. Adjust the sprayer's distance from the
surface and your hand speed to achieve
the desired surface coverage.
16

Spray Tip Orientation

To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip when installing or removing the Spray
Tip and Tip Guard.
NO
Adjust the Spray Tip Guard for the desired
vertical or horizontal spraying direction.
YES
3A9014A