Calibrating The Embroidery Hoop; Entering The Fabric Thickness - Bernina 700 Manual

Calibrating the embroidery hoop

The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
• The embroidery module is connected and the embroidery hoop with the appropriate embroidery
template is attached.
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Calibrate the embroidery hoop».
> Select the desired embroidery hoop and follow the instructions in the display.
> Touch the icon «Delete» (1) to delete the present calibration.
> Center the needle via the arrow icons on the display.
1

Entering the fabric thickness

If the fabric thickness is more than 4 mm as for e.g. toweling, it is recommended to select 7.5 mm or
10 mm. The thicker the fabric, the slower the embroidery speed of the machine. When the machine is
switched off, the alterations are reset to the default setting 4 mm.
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Select the fabric thickness».
> Select fabric thickness.
Setup Program
55