Table of Contents
Advertisement
Setting up Manual Interval Rec Single
Trigger mode
1
Select CACHE/INTVAL REC on the
REC FUNCTION page of the
OPERATION menu.
2
Turn the MENU knob to select M.INT,
and press the MENU knob.
As you turn the MENU knob, the setting
changes in the following sequence: OFF y
CACHE y A. INT y M. INT.
When M. INT appears, the camcorder is in
Manual Interval Rec mode and the TALLY
indicator (green) in the viewfinder flashes.
NUMBER OF FRAME, TRIGGER
INTERVAL and RE-LIGHTING appear.
3
Turn the MENU knob to select
NUMBER OF FRAME, and press the
MENU knob.
O05 REC FUNCTION
DF/NDF
END SEARCH
CACHE/INTVAL REC: M.INT
NUMBER OF FRAME :
TRIGGER INTERVAL:
4
Turn the MENU knob to select the
desired number of frames to be
recorded in each shot, and press the
MENU knob.
The number changes in the following
sequence: 1 y 2 y 4 y 8.
5
Turn the MENU knob to select
TRIGGER INTERVAL, and press the
MENU knob.
6
Turn the MENU knob to select M, and
press the MENU knob.
The number changes in the following
sequence: M y 1SEC y 2SEC........12H
y 24H.
When M appears, the TALLY indicator
(green) flashes (2 flashes/second) and PRE-
LIGHTING disappears.
70
Recording
TOP
:
DF
:
OFF
1
M
7
To end the menu operation, set the
MENU ON/OFF switch to OFF (or
close the cover).
The menu display disappears from the
viewfinder screen and the message "MANU
INTERVAL *FRAME", indicating the
Single Trigger mode of the Manual Interval
Rec mode, appears along the bottom of the
viewfinder.
"*FRAME" indicates the number of frames
set in step 3.
The display indicating the current status of
the camcorder appears along the top and
bottom of the viewfinder.
Note
The settings for Manual Interval Rec Single Trigger
mode are maintained until changed. However, if you turn
the camcorder off, all Manual Interval Rec mode settings
are cleared except for the NUMBER OF FRAME
setting. To use Manual Interval Rec Single Trigger mode
again after turning on the camcorder, perform steps 1 and
2.
Recording in Manual Interval Rec Single
Trigger mode
Follow the procedure below to shoot in of Manual
Interval Rec Single Trigger mode.
Note
When you use blank cassettes, such as brand new
cassettes, be sure to record color bars for more than 2
seconds at the beginning of a cassette.
1
After performing the basic procedures
for shooting and recording, following
the instructions in "Basic procedures"
(see page 61), secure the camcorder so
that it will not move.
2
Press the REC START button on the
camcorder or the VTR button on the
lens.
The camcorder starts recording in Manual
Interval Rec Single Trigger mode . The
TALLY indicator (green) in the viewfinder
flashes (2 flashes/second) and the message
"MANU INTERVAL *FRAME" flashes on
the viewfinder screen.
Each time you press the REC START button
or the VTR button, the camcorder captures
and stores picture data for the preset number
of frames. The REC indicator in the
Advertisement
Table of Contents
