Hardware Interfaces - NETGEAR WAX615 User Manual

Insight Managed WiFi 6 AX3000 Access Point Model WAX615
Table 1. LED descriptions (Continued)
LED Icon
5 GHz WLAN LED
Note: For information about troubleshooting with the LEDs, see Troubleshoot with the
LEDs on page 220.

Hardware interfaces

The bottom panel of the access point provides the DC power connector for an optional
power adapter, Reset button, LAN/PoE+ port.
Figure 2. Hardware interfaces
The bottom panel contains the following components:
• DC power connector: If you do not use a PoE+ switch to provide power to the
access point, connect an optional power adapter to the DC power connector.
• LAN/PoE+ port: Use the LAN/PoE+ Gigabit Ethernet RJ-45 LAN port to connect the
access point to a PoE+ switch, or if you use an optional power adapter, to a non-PoE
switch.
If connected to 2.5 Gbps equipment, the LAN PoE+ port supports Ethernet speeds
up to 2.5 Gbps within your LAN. If your Internet connection, modem, router, and
switch support a speed of 2.5 Gbps, the access point's Internet connection also
Hardware Overview
Color Description
Solid green: The 5 GHz WiFi radio is on but no clients are connected.
Solid blue: One or more WLAN clients are connected to the 5 GHz
WiFi radio.
Blinking blue: Traffic is detected on the 5 GHz WiFi radio.
Off: The 5 GHz WiFi radio is off.
13 User Manual