Table of Contents
Advertisement
5.
Pull open the spring latch on the outer edge of the oil bottle
retainer, and lift the retainer up and toward the center of the
printer (fig. 2.19).
NOTE: The spout of the oil bottle has a seal to prevent oil
from spilling until the bottle is installed on the pin in the fuser
slot.
6.
Hold the bottle, spout end down with the label facing the
printer's front, over the slot in the top of the fuser unit (fig.
2.19).
7.
Lower the bottle into place, making sure the spout on the
bottom of the bottle aligns with the pin in the fuser slot. The
bottle is positioned correctly when it fits snugly in the slot and
is flush with the top of the fuser unit.
Fig. 2.19 Install the Oil Bottle (rear view)
I n i t i a l P r i n t e r S e t u p
Chapter 2
2 - 2 7
Advertisement
Table of Contents
