Table of Contents
Advertisement
Chapter 9
4.
Remove any jammed media you see (fig. 9.3).
Fig. 9.3 Remove the Jammed Media
5.
Check to be sure no other pieces of media are lodged farther
back in the slot. Then, if you removed the manual-feed
platform, replace it. (Push it back into the printer until it is
secure.)
6.
Make sure the media in the cassette is in good condition, lies
flat, and does not exceed the upper-limit mark on the cassette.
7.
Slide the cassette back into the printer until it's secure.
8.
Open and close the top cover to clear the jam message in the
control panel window.
When the control panel message window displays IDLE, the
printer is ready to print.
9 - 8
T r o u b l e s h o o t i n g
Advertisement
Table of Contents
