Table of Contents
Advertisement
7.
Examine the ends of the two plastic support posts that come
with the daughterboard: one end has a slightly larger diameter
and the other end is slightly more tapered. Insert the larger
ends into the controller board.
8.
If you're installing a CrownNet interface board (which does
not require a daughterboard) skip to step 9. If your interface
kit came with a daughterboard, attach the daughterboard to
the two support posts and the two 48-pin connectors (fig.
8.20). (The daughterboard is keyed so that it fits only one
way.)
Fig. 8.20 Attach the Daughterboard to Support Posts
9.
Follow the instructions in "Replacing the Controller Board"
(earlier in this chapter), being careful to eliminate static
electricity.
10. If your interface kit came with an external power supply box,
attach it to the round connector next to the network interface
P r i n t e r O p t i o n s
Chapter 8
8 - 3 1
Advertisement
Table of Contents
