Parameter Assignment/Addressing; Parameter Assignment Addressing Prelude; Correspondence Between Drive Parameter Id And Communication Protocol Address - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

8.4

Parameter Assignment/Addressing

8.4.1

Parameter Assignment Addressing prelude

This section provides the following information for communication configuration and
programming:
• Drive parameter ID and corresponding communication protocol address
• Parameter tables:
– Network configuration parameters
– Network 1 configuration parameters
– Network 2 configuration parameters
• Pick-list variable tables:
– Data from Drive variables
– Data to Drive variables (with scaling and range)
8.4.2 Correspondence between Drive Parameter ID and Communication Protocol
Address
The following table provides drive parameter IDs and the corresponding register addresses. The
following data is provided:
• Parameter ID
The drive parameter ID number to enter via the keypad or the ToolSuite.
• DeviceNet™ Network Data
DeviceNet (Profile 12) uses a pre-defined byte count to communicate between the controller
and the drive.
– The drive uses up to 136 bytes for input and output. 28 bytes are used to form the 6416-
– The data received (128 bytes) is mapped to the 64 data to drive registers and the data sent
• Data From Drive
Data that the PLC will receive from the drive to determine how the drive is functioning.
Each register contains a 16-bit digital representation of the status of a particular aspect of
drive functionality.
Some registers are fixed to track certain drive functions and others are programmable to track
any of a number of drive status choices.
• Data To Drive
Data that the PLC will send to the drive to control it.
Each register contains a 16-bit digital representation of the PLC's command for a particular
aspect of drive functionality.
Some registers are fixed to control certain functions and others are programmable to control
any of a number of drive function choices.
NXGPro+ Communication Manual
Function Manual, AA, A5E50226719
bit registers (2 bytes per register).8 bytes are 'reserved' for future use.
to the PLC is defined using the 64 data from drive registers.
DeviceNet Communication
8.4 Parameter Assignment/Addressing
143