Parameter Assignment/Addressing; Parameter Assignment Addressing Prelude; Correspondence Between Drive Parameter Id And Communication Protocol Address - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

7.4

Parameter Assignment/Addressing

7.4.1

Parameter Assignment Addressing prelude

This section provides the following information for communication configuration and
programming:
• Drive parameter ID and corresponding communication protocol address
• Parameter tables:
– Network configuration parameters
– Network 1 configuration parameters
– Network 2 configuration parameters
• Pick-list variable tables:
– Data from Drive variables
– Data to Drive variables (with scaling and range)
7.4.2 Correspondence between Drive Parameter ID and Communication Protocol
Address
The following table provides drive parameter IDs and the corresponding register addresses. The
following data is provided:
• Parameter ID
The drive parameter ID number to enter via the keypad or the ToolSuite.
• Profibus™ Network Data
Profibus™ uses a pre-defined byte count to communicate between the controller and the
drive.
– The drive uses up to 136 bytes for input and output; 128 bytes are used to form the 6416-
– The data received (128 bytes) is mapped to the 64 data to drive registers and the data sent
– Network data size may be limited to 16, 32, 64, 96, 128, or 136 bytes for input and output
– Each network register is 16 bits (2 bytes). The order of the bytes can be swapped to match
NXGPro+ Communication Manual
Function Manual, AA, A5E50226719
bit registers (2 bytes per register); and 8 bytes are 'reserved' for future use.
to the PLC is defined using the 64 data from drive registers.
using parameter 'Network 1 I/O Size' (9951) or 'Network 2 I/O Size' (9952). At 136 bytes,
only 128 are available to the user. You must configure the Profibus™ controller to have the
same quantity of bytes.
the network data format (9953, 9954).
Profibus Communication
7.4 Parameter Assignment/Addressing
115