Table of Contents
Advertisement
Power User Tip: Once you have matched the levels of your full-range monitors and T8, don't use
their volume controls to adjust the overalllevel; instead, use the volume on your audio device
(computer, iPad, TV, etc.).This will ensure that your speakerlevels remain matched.
用户提示：一旦你匹配了全频监听器和 T8 的电平，不要使用它们的音量控制来调整整体
电平；而是使用音频设备（电脑、 iPad 、电视等）的音量。这将确保你的扬声器水平保
持匹配。
10
7.
Set the lowpass filter on your T8 to 130 Hz. This will create a frequency
overlap between your T8 and your full-range system.
将T8的低通滤波器设置为130Hz。这将在你的T8和你的全频系统之间产
生一个频率重叠。
8.
Playpink noisethroughyour fullsystemandexperimentwiththe polarity
switch on yourTemblorT8 to see which position providesthe best bass
response.Leave the polarity switch where the bass is the loudest.
通过你的整个系统播放粉红色噪音，并试验Temblor T8的极性开关，
看看哪个位置能提供最佳的低音响应。把极性开关放在低音最响的
地方。
9.
Now play some music through your system and experiment with the
low pass filter on your T8 until you find the most natural transition
full-rangemonitorsandyour subwoofer. If your full-
between your
rangemonitorsare connected to the outputs of your T8, you may
want to try turning on the 80 Hz highpass filter on theT8 and setting
the lowpass filter to 80 Hz.
现在通过你的系统播放一些音乐，并尝试使用T8的低通滤波器，直到
你找到全频监听和超重低音扬声器之间最自然的过渡。如果你的全频
监听器连接到T8的输出，你可能想尝试打开T8的80Hz高通滤波器，并
将低通滤波器设置为80Hz。
Advertisement
Table of Contents
