Interrupts/Diagnostic Message; Ethernet And Ip Address Assignment - Siemens SIMATIC Power Line Booster Operating Instructions Manual

DIP switch information data record
Context: BM
Index: 110
Type: Read Only
The position of the DIP switches read during switch on of the PLB is transferred. The value is
transferred as BYTE (unsigned8).
Bit 7
CH 1
* DIP switch currently without function. The switch position read during switch on is transferred.
5.1.6

Interrupts/diagnostic message

There are no interrupts or diagnostic messages in the Power Line Booster.
5.2

Ethernet and IP address assignment

If you do not operate the Power Line Booster as a PROFINET device or do not couple it with
an IO controller, you must use the PROFINET mechanisms (DCP) to assign the IP address
(e.g. for update). Regardless of the application, you can use the same tools (STEP 7, PST,
PRONETA, etc.) that are customary in the PROFINET environment. See the Function
Manuals for more information.
Note
For additional information on "PROFINET IO", refer to the STEP 7 online help and the
PROFINET System Description
(http://support.automation.siemens.com/WW/view/en/19292127)
Note
The Power Line Booster supports a packet size of 1522 / 1518 bytes (VLAN tagged /
untagged). Any larger packet sizes are discarded.
Power Line Booster
Operating Instructions, 11/2019, A5E36203125A-AG
Bit 6 Bit 5
CH 0 *
5.2 Ethernet and IP address assignment
Bit 4 Bit 3
* *
PROFINET/Ethernet
Bit 2 Bit 1
* *
Bit 0
M/S
71