System Time; Setting The Time Manually - Siemens SIMATIC Power Line Booster Operating Instructions Manual

6.3.6

System time

System time (master only)
You can synchronize the system time of the Power Line Booster either automatically via an
NTP server or enter it manually. You make the setting in the two tabs on this page. You can
set synchronization of the time only on the master. The slaves always get their time from the
master to which they are currently connected.
Note that the PLB does not retain the time if the supply voltage is interrupted.
6.3.6.1

Setting the time manually

Figure 6-12 Setting the time manually
Setting the time manually
In addition to an automatic update of the time, you can also set the time manually on the
master. To do so, you either enter the time manually in the entry field or you use the system
time of your computer via the button. The Power Line Booster applies the time in the entry
field as the new system time after pressing the button.
Power Line Booster
Operating Instructions, 11/2019, A5E36203125A-AG
System configuration and system status (web interface)
6.3 System
93