Table of Contents
Advertisement
System configuration and system status (web
interface)
6.1
Overview of web interface
The Power Line Booster is commissioned and configured via the integrated web interface.
The web pages of the Power Line Booster differ depending on whether you are configuring a
PLB master or a PLB slave. In this help document, you will always see the setting options of
the PLB master. The web pages of the PLB slaves have fewer setting options. Note that you
as the "admin" user have far-reaching options for configuring the device. It is also possible
that you configure the system to the point that communication is no longer possible!
Note
Modern browsers cache the content of web pages to optimize loading. If you experience
display problems or after switching a PLB from "Master" to "Slave" mode, it may therefore be
necessary to restart the browser and delete the cache.
6.1.1
Print preview
All pages are also available in a view optimized for printing. If you want to save
measurement results in particular, it is recommended to use this function via the respective
save button and to archive the results as PDF. For measurement results, additional
information is also output in this view.
Note
The Power Line Booster continuously checks the connection between the device and the
web browser. If the connection is inadvertently terminated (network cable unplugged without
previous logoff), the PLB automatically terminates the active sessions after a few seconds.
Some browsers block all actions of the website during the print preview. Therefore, it can
happen that you are logged out of the device if the print preview is open for too long and you
then have to log on again.
Power Line Booster
Operating Instructions, 11/2019, A5E36203125A-AG
6
77
Advertisement
Table of Contents
