Advertisement
Description of the item on screen follows:
Quick Boot
Set this option to Enabled to permit AMI
seconds. This option replaces the old ABOVE 1 MB Memory Test option.
The Optimal default setting is Enabled. The Fail-Safe default setting is
Disabled.
1st Boot Device/2nd Boot Device/3rd Boot Device/4th Bood
Device
This option sets the sequence of boot drives.
The settings are:
IDE0
IDE1
IDE2
IDE3
F(optical)
SCSI
Network
CD-ROM
Disable
Try other Boot Devices
This option sets the device boot, if all the Four Boot Devices failed.
Initial Display Mode
This option sets the device boot, if all the Four Boot Devices failed.
Add-On ROM Init
This option sets the device boot, if all the Four Boot Devices failed.
Hard Disk Access Control
This option sets the Hard Disk to Read-only or Read-Write. During
Read-Only, if you try to write on the Hard Disk, the system will halt.
The system will boot from the first HDD.
The system will boot from the Second HDD.
The system will boot from the Third HDD.
The system will boot from the Fourth HDD.
The system will boot from LS-120(120M Floppy).
The system will boot from the SCSI.
The system will boot from the Network drive.
The system will boot from the CD-ROM.
Disable this sequence.
3-6
®
®
BIOS to boot within 5
Advertisement
