Embedded Web Interface (Optional); Application Save And Reset - Daikin EWWQ-KC Operating Manual

2.5.

Embedded Web Interface (Optional)

The POL468.85/MCQ/MCQ controller has an embedded web interface, available with accessory EKRSCBMS (Connectivity for
external BMS communication), that can be used to monitor the unit when connected to a TCP-IP network. It is possible to
configure the IP addressing of the POL468.85/MCQ as a fixed IP of DHCP depending on the network configuration.
With a common web browser, a PC can connect with the unit controller entering the IP address.
When connected, it will be required to enter a username and a password. Enter the following credential to get access to the web
interface:
User Name: ADMIN
Password: SBTAdmin!
2.6.

Application Save and Reset

Every variations of the HMI parameters will be lost after a power loss and it's necessary to execute a saving command to make
them permanent. This action can be done via the Application Save command.
The controller automatically makes an Application Save after a change of value of one of following parameters:
WARNING Some parameters present in the interface require a restart of the UC to become effective after a
change of value. This operation can be done using the Apply Changes command.
These commands can be found in Page [23]:
The path in the Web HMI interface for Application Save is "Main Menu".
The path in the Web HMI interface for Apply Changes is "Main Menu → View/Set Unit → Controller IP Setup → Settings".
Parameters Name
Unit Enable
1.00
Circuit 1 Enable
1.01
Circuit 2 Enable
1.02
Available Modes
2.00
Control Source(da collegare in sapro
4.00
se necessario)
Cool Setpoint 1
5.00
Cool Setpoint 2
5.01
Heat Setpoint 1
5.02
Heat Setpoint 2
5.03
Evaporator Delta T setpoint
8.07
Condenser Delta T Setpoint
8.20
Thermostatic Source Control
9.09
DHCP Enable
13.00
Number of circuit
14.03
Evaporator Pump control mode
14.01
EWT Sensor Enable
15.03
Water reversing valve Normal
15.10
behaviour
Water reversing valve Delay To Cool
15.11
Water reversing valve Delay To Heat
15.12
Low Pressure Unload Restart Number
15.13
Low Pressure Alarm First Run Delay
15.16
Reset Type
18.00
Bas Protocol
19.15
Menu Parameter
20 00 (Application Save)
(PLC) 01(Apply Changes)
R/W
W
W
D-EOMHP01501-22_00EN 5/29