Table of Contents
Advertisement
MLA MINI
USER GUIDE
PRESET 2: POLE MOUNT WITH UNIVERSAL TILT BRACKET
The rigging procedure for Preset 2 is very similar to that for Preset 1, with the exception that the
Universal Tilt Bracket must be used, as the overall array tilt is 17.5°, an angle not achievable
with the Fixed Tilt Bracket.
Step1: As for Preset 1
Step 2: As for Preset 1
Step 3: As the Bracket Tilt Angle for Preset 2 is 17.5°, the Universal Tilt Bracket must be used.
Attach the bracket to the top of the telescopic pole and secure by tightening the boss onto the
pole using the knob. Assemble the Universal Bracket for pole mount operation as described in
its accompanying assembly instructions.
Step 4: Lift the first MLA Mini cabinet onto the Universal Tilt Bracket. The lugs on the ends of
the main cross-arm should mate with the slots in the front corners of the cabinet. Secure these
points with flying pins. Attach the rear lug of the bracket to the Ground Stack hole (marked with
a
) in the cabinet's rear mounting plate. Secure with a Flying Pin. Using the rear adjustment
knob, set the tilt angle to 17.5°; the angle can be seen by observing the calibration hole at the
right-hand side.
MLA Mini User Guide V1.0
30
Advertisement
Table of Contents
