Table of Contents
Advertisement
MLA MINI
USER GUIDE
INSTALLATION
SYSTEM COMPONENTS
A range of rigging accessories is available for the MLA Mini system. The accessories required for
each rigging configuration differ; depending on what was specified at the time of order, you may
not have all the components shown below.
Before rigging the MLA Mini system for the first time in any configuration, you should first
familiarise yourself with each of the various components and their purpose.
Flying Frame
This steel assembly is required when an MLA Mini system is to be flown using one or two chain
hoists; it attaches either to the 4 x Mini array or to the MSX, depending whether the MSX is
being flown as part of the array. It is also used to attach a 4 x Mini assembly to the MSX sub
in a ground stack arrangement, or a 4 x Mini array directly to the Ground Stack Baseplate in a
situation where the MSX sub is located separately.
Clinometer
A clinometer is available to check the angle at which the MLA Mini array is flown at (relative to
the horizontal). It consists of a sensor (mounted within the Flying Frame) and a remote display
unit. Interconnection is via a standard XLR mic cable. It is normally only supplied with the
touring package.
Transition Frame
This is used in a flown arrangement to attach a 4 x Mini array to the underside of an MSX sub.
MLA Mini User Guide V1.0
12
Advertisement
Table of Contents
