AEG CIB6646ABM User Manual page 39

Problem
Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on the hob dis‐
play.
comes on the hob dis‐
play.
comes on the hob dis‐
play.
comes on the hob dis‐
play.
comes on the hob dis‐
play.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation
settle on the food and in the
cavity of the oven.
There is no good cooking
performance using the True
Fan Cooking PLUS function.
Possible cause
The highest heat setting is
set.
Power management function
operates.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The lamp is defective.
There was a power cut.
You left the dish in the oven
for too long.
You did not fill the cavity em‐
bossment with water.
ENGLISH
Remedy
The highest heat setting has
the same power as the func‐
tion.
Refer to "Hob - Daily use"
chapter.
Put large cookware on the
rear zones if possible.
Activate the signals. Refer to
"Hob - Daily use" chapter.
Deactivate the hob and acti‐
vate it again.
Refer to "Hob - Daily use"
chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hob - Hints and
tips" chapter.
Use cookware with correct
dimensions. Refer to "Hob -
Hints and tips" chapter.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Activating the True
Fan Cooking PLUS func‐
tion".
39