Tuning In A Preset Station; Receiving Fm Stations With Rds - JVC CA-MXS6MDR Instructions Manual

To preset stations manually — Manual Presetting
1
Tune in the station you want to preset.
• See "Tuning in a Station" on page 16.
2
Press SET.
The preset number starts flashing.
3
Select a preset number.
On the remote control:
Press the number buttons.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
On the unit:
Push the joy control rightward ( ) or leftward ( ).
• Rightward ( ): to increase the preset numbers.
• Leftward ( ): to decrease the preset numbers.
4
Press SET again.
The tuned station in step 1 is stored in the preset
number selected in step 3 .
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.

Tuning in a Preset Station

1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM–MW/LW).
• Each time you press the button, the band alternates
between FM and AM (MW/LW).
2
Select a preset number.
On the remote control:
Press the number buttons.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
On the unit:
Push the joy control rightward ( ) or leftward ( ).
• Rightward ( ): to increase the preset numbers.
• Leftward ( ): to decrease the preset numbers.

Receiving FM Stations with RDS

RDS allows FM stations to send an additional signal along
with their regular program signals. For example, the
stations send their station names, as well as information
about what type of program they broadcast, such as sports
or music, etc.
When tuned to an FM station which provides the RDS
service, the RDS indicator lights on the display.
With the unit, you can receive the following types of RDS
signals.
PS (Program Service):
Shows commonly known station names.
PTY (Program Type):
Shows types of broadcast programs.
RT (Radio Text):
Shows text messages the station sends.
EON (Enhanced Other Networks):
Provides the information about the types of the
programs sent by other RDS stations than the one
being received.
RDS operations are possible only using the remote
control. You can use the buttons printed in orange on
the remote control.
• REMEMBER, after using these buttons for RDS
operations, make sure to change the operation mode
of the remote control to the one you want to use next
by pressing MD 3 / 8, CD 3 / 8, or FM/AM.
– 17 –