Listening To Fm And Am Broadcasts; Tuning In A Station; Presetting Stations; Tuning In A Preset Station - JVC MX-J170VUS Instruction Manual

Listening to FM and AM Broadcasts

Tuning in a Station

1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Select a station.
On the unit:
Press and hold 1 or ¡ for more
than 1 second.
On the remote control:
1) Press TUNING MODE so that
"MANUAL" appears on the
display.
2) Press and hold 4¥1 or
¢¥¡ for more than 1
second.
The unit starts searching for stations and
stops when a station of sufficient signal
strength is tuned in.
If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop during searching, press 1 or ¡ (or 4¥1 or
¢¥¡ on the remote control).
When you press 1 or ¡ (or 4¥1 or ¢¥¡
on the remote control) briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so
that the MONO indicator lights up on the display.
Reception improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
The FM reception mode is restored even when the unit is
turned off.

Presetting Stations

You can preset 30 FM, 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1
Tune in the station you want to preset.
• See "Tuning in a Station" to the left.
FM/AM
2
Press PROGRAM/SET.
- VCD NUMBER
The PRGM flashes on the display.
VCD NUMBER +
3
Press PRESET – or + to
select a preset number.
TUNING MODE
4
¢
1
¡
PREV
NEXT
4
Press PROGRAM/SET again.
The tuned station in step 1 is stored in the
preset number selected in step 3.
• Storing a new station on a used number
erases the previously stored one.
The preset stations will be erased in a few days. If this happens,
preset the stations again.

Tuning in a Preset Station

FM MODE
1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Select a preset number.
On the unit:
Press PRESET – or +.
On the remote control:
1) Press TUNING MODE so that
"PRESET" appears on the
display.
2) Press 4¥1 or ¢¥¡.
– 11 –
MHz
PRGM
PRGM
When you unplug the AC power cord or if a power
failure occurs
PROGRAM/SET
PREV NEXT
+
– PRESET
PROGRAM/SET
FM/AM
PREV NEXT
+
– PRESET
TUNING MODE
¢
4
¡
1
NEXT
PREV