Loading Cds; Playing Back The Entire Discs - Continuous Play - JVC CA-MXS6MDR Instructions Manual

Loading CDs

On the unit ONLY:
1
Press one of the open/close buttons (0 CD1, 0 CD2,
or 0 CD3) for the disc tray you want to load a CD
onto.
The unit automatically turns on and the selected disc
tray comes out.
2
Place a CD correctly on the circle of the disc tray,
with its label side up.
Good
• When using a CD single (8 cm), place it on the
inner circle of the disc tray.
3
Press the same open/close button (0 CD1, 0 CD2,
or 0 CD3) you have pressed in step 1 .
The disc tray closes.
4
Repeat steps 1 to 3 to place other CDs.
When loading more than one CD continuously
Press the open/close button (0 CD1, 0 CD2, or 0 CD3) for the
next tray you want to place a CD onto. The first disc tray
automatically closes and the next disc tray comes out.
About the CD indicators
Each disc number indicator (
the disc tray of the same number.
Lights when a disc on the corresponding disc tray is
currently selected.
No good
) corresponds to
– 23 –
Playing Back the Entire Discs — Continuous
Play
You can play CDs continuously.
1
Load CDs.
2
Select a disc number you want to start play with.
On the remote control:
Press one of the disc number buttons (CD1, CD2
and CD3).
On the unit:
Press DISC repeatedly to select the disc number you
want, then press CD # / 8.
CD playback starts from the first track of the selected
disc.
This shows the currently selected disc.
Track No.
• Pressing CD 3 / 8 without selecting a disc number
starts playing back the currently selected CD.
To stop during play, press 7.
To remove the disc, press the corresponding open/close
buttons (0 CD1, 0 CD2, or 0 CD3).
CD playback sequence
When 3 CDs are loaded on the disc trays, they are played in one of
the following sequences.
• When CD 1 is the starting disc : CD 1 ] CD 2 ] CD 3 (then
stops)
• When CD 2 is the starting disc : CD 2 ] CD 3 ] CD 1 (then
stops)
• When CD 3 is the starting disc : CD 3 ] CD 1 ] CD 2 (then
stops)
* If no CD is on the disc trays, CD player skips such an empty
tray.
Goes off when the unit has recognized that there is
no CD on the corresponding disc tray.
Flashes during play or pause.
Lights when the CD player is selected as the
source.
Elapsed playing time