Tuning Into A Preset Station - JVC NX-CDR7 Instructions Manual

To preset stations manually--Manual Presetting
On the remote control ONLY:
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
Tune into a station you want to preset.
• See "Tuning into a Station" on page 18.
_oFM 8 8. 3 0MH:;i::
Press SET.
The preset number appears and starts flashing.
_ _o F:: M ..... F ::'
Press the number buttons to select a preset number.
/_'_'_,
Ex.: When selecting preset number "8"
Ex.: For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
For preset number 30, press +10, +10, then 10.
Press SET again.
"MEMORY" appears in the main display, and the tuned
station in step 1 is stored in the preset number selected
in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or ifa power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning into a Preset Station
On the remote control ONLY:
Press SOURCE repeatedly until FM or AM is
;_ selected.
_o F:: ! "! ! 8 ..:::' ,, 5 0 !"!H ::!::
Ex.: When selecting FM
Press the number buttons to select a preset number.
_o F:: i "[ ==iii: ==i?= ==iii: ,, 3 0 ["i[i :;!'.:
Ex.: When selecting preset number "8"
Ex.: For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
For preset number 30, press +10, +10, then 10.
-19-