Table of Contents
Advertisement
3 Safety information and instructions on preparing
the case safely
3.1 Setting up the case
Please make sure that the case is placed fully on a stable work surface.
This helps to avoid any injuries which could occur if the training case were
to fall from the work surface as well as any associated damage to the
training material.
Also make sure there is enough space to use a laptop and mouse.
You can then open the lid. The lid of the training case has been purposely
designed with two hinges that lock into place so that the lid cannot fall
down if someone inadvertently touches or knocks the case as they walk
past, thereby preventing people from being injured when they are working
with the case.
Plug the power cable firmly and securely into the IEC socket inside the
case. The case is equipped with an internal fuse (1.25 A T) right next to
the IEC socket, which can also be replaced by the customer (not by the
learners).
Only the supplied power cord may be used.
The mains plug may only be plugged into an earthed socket.
The earthed plug or the IEC plug of the mains cable must always remain
accessible, so the mains cable can be disconnected in an emergency.
The device is suitable for use in schools for supervised pupils aged 11
years or older.
Manual for the training case KNX
Safety information and instructions on preparing the case safely
6
Advertisement
Table of Contents
