Ccd Camera Operations - Clarion MAX983HD Owner's Manual

CCD Camera Operations

If the optional CCD rear camera is installed in this system, the rear view image is displayed on the screen
when the gear lever is put in the reverse gear position. In addition, this system can display guidelines on
the camera image, which helps you to perceive the size of the vehicle.
Note:
• The CCD camera image is not displayed on the
rear monitor.
Displaying the Guidelines on
the camera image
1. Touch the screen when the rear view image is
displayed.
The [Guide line] key is displayed.
• The [Guide line] key will disappear 3
seconds later.
2. Touch the [Guide line] key.
A confirmation screen is displayed.
3. Touch the [OK] key.
The guidelines are displayed on the screen
image.
• Touching the [Guide line] key turns the
guidelines display on/off.
Adjusting the guidelines
position
You can adjust the position of the guidelines so
that the size of the vehicle is represented.
1. Display the guidelines by the procedure
previously described.
2. Touch the [Setting] key.
The four control point appears on the
guidelines, and the control keys appear at the
bottom of the screen.
3. Select the control point you wish to adjust the
position by touching it, then move the control
point by using the [e], [E], [
[e], [E], [ ], [ ]:
Touching these keys moves the selected
control point by 1 dot.
Touching and holding these keys moves the
selected control point by 5 dots.
[Camera]:
Hides/displays the camera image.
[Grid]:
Displays/hides the grid on the screen.
4. When the adjustment completes, touch the
[Back] key to quit the adjustment mode.
], or [ ] key.
59
MAX983HD