Voice Recognition - Clarion MAX983HD Owner's Manual

General Settings
"Time Zone":
Sets the time zone. You can select from the
list of 74 regions including the [Auto] key.
When you select the [Auto] key, the clock is
automatically switched to the time zone of the
country at the vehicle position.
Changing Skin
You can change the screen design by using the
skin data stored in the hard disk drive.
1. Touch the [Select] key of the "Skin Change"
item.
2. Touch the desired item key you wish to set.
Note:
• This operation is disabled while recording a CD or
loading/ejecting a disc.
Beep Sound
You can turn ON/OFF the beep sounds and
menu operation sounds.
Keyboard Type
You can change the keyboard layout used for
name entry.
1. Touch the item key of the "Keyboard" item.
2. Select the keyboard type by touching one of
the following keys:
[ABCDEF] key
[QWERTY] key
[QWERTZ] key
[AZERTY] key

Voice Recognition

You can turn ON/OFF the voice recognition
feature (optional). When you touch the [OFF]
key, the voice recognition is not available.
Voice Feedback
You can turn ON/OFF the voice feedbacks which
are responded when using voice commands.
Blinking LED
When this function is set to "ON", the Blinking
LED indicator will blink when the power is turned
off.
64
MAX983HD
Antenna
Select the [Auto Antenna] when your vehicle
has the auto antenna.
Note:
• When the "Auto Antenna" is selected, you can
extend/collapse the antenna by keeping pressing
the [ INFO] button more than 2 seconds. Be sure
to collapse the antenna before entering in a place
with low ceiling such as a multistory car park.
• Select [Others] for the vehicle equipped with no
auto antenna. Otherwise, the radio reception may
be disturbed extremely.
Security Mode
To set this function ON, setting a PIN code
(called as "Personal Code") is required. When
you set your Personal Code, a theft is prevented
by disabling the operation of the unit.
In addition, set the Blinking LED function to "ON"
to improve the effect of this function.
Setting the Security Mode
1. Touch the [ON] key of the Security Mode item.
The Set Code screen appears.
2. Enter your desired 4-digit Personal Code by
using Ten-Key pad displayed on the screen,
then touch the [OK] key.
• Touch the [ ] key when you make a
mistake in entering.
3. Enter the same Personal Code again for
confirmation, then touch the [OK] key.
The entered Personal Code will be set, and it
will return to the previous screen.
Resetting the Security Mode
1. Touch the [OFF] key of the Security Mode
item.
The Erase Code screen appears.
2. Enter your 4-digit Personal Code by using
Ten-Key pad, then touch the [OK] key.
The message "Code erased" appears, and it
will return to the previous screen.
Personal Code entry
The Personal Code screen will be displayed
when turning the power on after performing the
following operations:
• The car battery was replaced.
• The backup power was cut off.
• The Reset button was pressed.
Note:
• If you forgot your Personal Code, please consult
your dealer or an authorized service centre.