Wire Connection - Clarion MAX983HD Owner's Manual

Wire Connection

• Disconnect the negative terminal of the battery before connecting wires, otherwise an
electric shock, injury by short circuit may occur.
• Be sure to read the section "Wire Connection Notes" before installation or connection
operations.
Note:
• For the optional devices, use the RCA pin cable and other connector cables sold separately.
Microphone
for voice
control
iPod
connector
cable
IR remote controller sensor
CeNET terminal
Video output for rear monitor
RCA pin
Video input for TV tuner/AUX
lead
Audio output for rear monitor
Audio
input for
AUX
WARNING
Vehicle signal lead
Pink
Grass-green
Purple/White
Power supply
lead
Refer to the following figure.
Speed sensor lead
Connect to the EC (Engine Control Computer)
vehicle speed signal line.
Parking brake signal lead
Connect to the parking brake signal line.
Reverse gear signal lead
Connect to the + terminal for the reverse gear
lamp that is only fed when the transmission is
put in reverse.
RDS-TMC antenna terminal
CCD camera terminal
CeNET cable
GPS antenna
VTR etc.
or
TV tuner
Rear
monitor
MAX983HD
87