Advertisement
2
Battery Cover
Battery Cover Catch
Figure 3
TYPE 'C'
LR14
TYPE 'C'
LR14
Figure 4
Figure 5
P E
T Y
C
Figure 6
3. Install 2 alkaline "C" batteries. Press in
catch on bottom of battery cover and lift to
remove (see Figure 3). Make sure batteries
are oriented properly (see Figure 4).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push
button work properly. If chime does not sound,
see Troubleshooting.
5. Mount push button. Use either screws or
double sided tape to mount push button.
• Screw Mounting: To mount with screws,
remove back of case by pushing in tab on
UP
MODEL: WL-102D
bottom with a small screwdriver (see Figure
1). Note: Remove material in screw holes
(if needed) before mounting with screws.
Attach back of case to door jamb or wall (see
Figure 5). Snap front of push button on.
• Tape Mounting: When attaching push but-
SYNC – HOLD 3 SECONDS
RESET – HOLD 10 SECONDS
ton using double sided tape, make sure the
surface of the door jamb or wall is clean.
6. Mount chime base. Determine mounting
location.
• Place chime against wall and verify the
chime is level. Note: See chime base for
correct orientation.
• Use all 4 chime mounting holes as a tem-
plate (see Figure 6).
• Drill 7/32" diameter pilot holes for wall an-
chors (provided) and insert anchors. Note:
Always use wall anchors if not mounting
directly into a stud.
• Verify chime is level and tighten screws
securely.
• Press chime cover onto chime base.
Advertisement
