Table of Contents
Advertisement
Installing the system fan
To install the system fan, complete the following steps.
1. Locate the rubber grommets that you removed from the defective fan. Use
2. Position the fan so that the grommets protrude through the holes in the chassis;
3. Connect the fan cable to the system board (see "System-board internal
4. Install the cover (see "Installing the cover" on page 58).
5. Reconnect the external cables and power cords to the server; then, connect the
6. Turn on the attached devices; then, turn on the server.
Rubber
grommets
System fan
needle-nosed pliers to pull the grommets through the holes in the replacement
fan.
then, use needle-nosed pliers to pull the grommets through the holes from
outside the chassis.
connectors" on page 8 for the location of the system fan connector).
power cords to electrical outlets.
Chapter 4. Removing and replacing server components
75
Advertisement
Table of Contents
