Table of Contents
Advertisement
Removing an adapter
To remove an adapter, complete the following steps.
Expansion-slot
screw
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all peripheral devices; then, disconnect the power cords
3. Disconnect any cables from the adapter.
4. Remove the cover (see "Removing the cover" on page 57).
5. Remove the expansion-slot screw for the adapter to be removed.
6. Carefully grasp the adapter by its top edge or upper corners, and pull the
7. If the server will be used before a replacement adapter is installed, install an
8. If you are instructed to return the adapter, follow all packaging instructions, and
9. If you are not returning the adapter, store it in a safe place for reuse.
on page 55.
and all external cables.
Note: It might be helpful to lay the computer on its right side for the remainder
of this procedure.
adapter from the server.
expansion-slot cover in the slot.
Note: Expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the server and ensures proper
ventilation of server components.
use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing server components
61
Advertisement
Table of Contents
