Hitachi GS4000 Series Quick Start Manual page 41

Procedure 1.
Attach a power cable
Attach power cables to all the power supply units in GS4000-320E (AC).
When connecting the device to a power supply unit, use only grounded
Warning
power outlets. Failing to use grounded outlets creates a shock hazard.
Use the power cable provided with a chassis. If you use a power cable other
Warning
than this, it could cause a fire or an electric shock.
Before attaching a power cable, make sure that all the switches of GS4000 are
NOTE
turned OFF.
Procedure 2.
Install a memory card.
Insert a memory card into both the memory card slot 0 and the memory card slot 1 of a basic control unit (BCU0). Memory
cards must be installed into both BCU0 and BCU1 in case that a basic control unit is redundant.
Caution While the access indicator of BCU (ACC lamp) is lit, the memory card is being accessed. DO NOT
pull out a memory card or turn off the power switch while the memory card is being accessed. If
so, you could permanently damage the memory card.
NOTE When inserting a memory card, the surface labeled with the part number "HN-F9244-66X" should
be faced up.
NOTE Use a standard type of memory card provided by HITACHI. The operation cannot be guaranteed if
a memory card other than that is used.
When installing a memory card using an option license for GS4000, make sure that the
manufacturing number of a device put on the label of a memory card matches the serial number
of an option license. (You can check these numbers using a packing list provided with GS4000.)
Procedure 3.
Connect a setup terminal to GS4000-320E (AC).
1．
Connect a setup terminal to the CONSOLE port of BCU (BCU0) using a RS－232C cross cable.
2．
Start up a setup terminal.
3．
Start up communication software
NOTE GS4000-320E (AC) is pre-configured in a way that a setup terminal can be connected to a
CONSOLE port of BCU0 when it is shipped from the factory. Connect a setup terminal to a
CONSOLE port of BCU0 in case that a basic control unit is redundant.
NOTE As for the setup of communication software, see the communication software manual.
QSGGS4KX10-00 5794092-2X
GS4000 Quick Start Guide, Revision 3
23