Explanatory Photos for DISASSEMBLY
• For the shooting direction of each photos used in this manual, see the photo below.
• A, B, C and D in the photo below indicate the shooting directions of photos.
• The photographs with no shooting direction indicated were taken from the top of the unit.
• Photos of SR5012 U are used in this manual.
The viewpoint of each photograph
(Shooting direction : X) [View from the top]
↓Shooting direction: B↓
↑Shooting direction: A↑
1. WiFi ANT
Proceeding :
TOP COVER
WiFi ANT
→
(1) Remove the INSULATION SHEET. Cut the wire clamps.
↑Shooting direction: A↑
�
View from the TOP
NOTE : ・If the INSULATION SHEET has been removed, replace with a new sheet.
・ When attaching the INSULATION SHEET, align with the Silk-Print and up to side of the NET-
WORK MODULE PCB.
・Fix with tape in position A.
2. FRONT PANEL ASSY
Proceeding :
(1) Remove the screws.
(2) Remove the screws. Remove the CORD HOLDER and connectors. Remove the FFC.
INSULATION SHEET
INSULATION SHEET
75
TOP COVER
→
FRONT PANEL ASSY
x8
View from the bottom
x4
CORD HOLDER
FFC
N1008
FFC
↑Shooting direction: A↑
CP4400