Marantz SR5012 Service Manual page 146

Paths to be confirmed Display
HDMI CEC
V04CEC
4 (Control Monitor : fig.10
***.*dB
HDMI Monitor1)
HDMI Audio fig.11a
V05H-AVR
5
(Audio : AVR) fig.11b
***.*dB
HDMI Audio
V06H-TV
6 fig.12
(Audio : TV)
***.*dB
V07MENU
7 GUI fig.13
***.*dB
Settings
Input Source : CBL/SAT
HDMI Control : On
MAIN ZONE : On
ZONE2 : Off
Input Source : CBL/SAT
HDMI Control : Off
HDMI Audio : AVR (if checking the audio output from
AVR)
HDMI Audio : TV (if checking the audio output from TV)・ HDMI input (PCM , DolbyDigital , DTS) ⇒ HDMI output (audio output from connected TV)
Input Source : CBL/SAT
IP Scaler : On, All sources
Resolution : "AUTO", All sources
Setup Menu : On
MAIN ZONE : On
ZONE2 : Off
146
What to confirm
・ When the power supply of a TV is put in the standby mode, make sure that the power supply
of this unit is also put in the standby mode.
( b The input source can be switched to any source except CBL/SAT.)
・ The ARC path can also be checked (check this using the TV input source).
・ HDMI input (PCM , DolbyDigital , DTS) ⇒ Speaker output.
・ HDMI input(HD audio) ⇒ Speaker output.
( b The input source can be switched to any source except CBL/SAT.)
( b The input source can be switched to any source except CBL/SAT.)
・GUI display ⇒ HDMI output.
( b The input source can be switched to any source except CBL/SAT.)