Table of Contents
Advertisement
6 USING THE SYSTEM
K Input the IP address of the primary and secondary DNS servers as necessary.
L Input the IP address of the primary and secondary WINS servers as necessary.
M Input the Intelligent Controller's device name (device ID) (within 15 characters).
(This is used to identify the Intelligent Controller when using DNS, for example.)
N For details on the mail server settings, see "6.8.10.1 Detailed server settings".
* Refer to the network administrator for confi rmation of detailed mail and network settings.
* If a Web browser (on PC) was used to change any of the settings from
have changed. Restart the unit." message appears and the Intelligent Controller restarts automatically.
* If you change the settings for items
when you switch to other screens.
* You cannot set the IP address to "0.0.0.0" or "255.255.255.255". You cannot set the subnet mask,
default gateway, DNS, or WINS to "0.0.0.0".
6.8.10.1 Detailed server settings
From the "WEB settings" screen (
following screen.
This screen enables you to use the same and actual mail server settings to set up the Intelligent
Controller as well. Therefore, check your mail server settings in advance and then apply the
same settings to the Intelligent Controller.
C
D
E
F
G
A Specify a port to use for sending mails, using a number within 6 digits.
B Select an encryption type to use for sending mails: "None", "SSL", "TLS", or "STARTTLS".
C Select this check box if you want to perform authentication during mail transmission.
Settings D to H below are valid only when you have selected this check box.
CZ-256ESMC1U̲改.indb 70
CZ-256ESMC1U̲改.indb 70
H
and
N
, the system restarts so that the new settings are refl ected
6
10
6
10
), clicking the "Server details" button displays the
Main
Sub
A
70
6
6
Main
Sub
H
to
K
, the "Network settings
10
10
B
G
2011/11/11 11:25:46
2011/11/11 11:25:46
Advertisement
Table of Contents
