Lcd Auto Off Settings; Calibrating Touch Panels - Panasonic CZ-256ESMC1U Operating Instructions Manual

Hide thumbs Also See for CZ-256ESMC1U:

Table of Contents

6 USING THE SYSTEM

6.8.9.6 LCD auto off settings

F The auto display off settings allow you to select a time after which the LCD display should be

automatically turned off if there is no activity. The LCD display is turned on again when you

touch it.

Settings: 5 minutes, 10 minutes, 15 minutes, 30 minutes, OFF (default: 30 minutes)

Turning the LCD display off when it is not in use saves power and can prolong the life of the

display and backlight.

Humidity and temperature around the Intelligent Controller and its secular change may affect the

point on the touch panel screen to deviate after use over a long period of time. In such a case,

Calibrate the position.

G Press Calibration and the next screen will be displayed.

Now press Yes and a cross mark will appear in the center of the screen.

Keep pressing the center with a touch pen for a second or longer and stop pressing. Follow

the same procedure of Upper left → Lower left → Lower right → Upper right.

Finally the cross mark disappear and "New calibration settings have been measured." will be

displayed. Then press somewhere on the screen and the result of calibration will become

effective to restore the original screen.

When 30 seconds passes without operating the screen, the calibration result is cancelled to

restore the previous screen.

CZ-256ESMC1U̲改.indb 67

End

Start

Main

Sub

2011/11/11 11:25:44

Table of Contents