Planar UltraRes P Series User Manual page 55

Vertical Active (URP75 / URP85 only)
•
The number of active lines in a field
•
Range: 0~4095
Vertical Refresh Rate (URP75 / URP85 only)
•
The number of fields per second rounded to the nearest Hz
•
Range: 0~120
Fully Specified (URP75 / URP85 only)
•
Determine how the final detailed timing is calculated. If disabled, it is calculated based on
Horizontal Active, Vertical Active, and Vertical Refresh Rate values. If enabled, it is
calculated based on all of the EDID values except for Vertical Refresh Rate.
•
Options: Disabled, Enabled
•
Note: This setting should only be enabled by advanced users.
Pixel Clock (URP75 / URP85 only)
•
The value of the pixel clock, in megahertz
•
Range: 0~600.00, in 0.01 increments
Horizontal Blanking (URP75 / URP85 only)
•
The number of non-active pixel clocks in a line
•
Range: 0~1023
Horizontal Front Porch (URP75 / URP85 only)
•
The number of pixel clocks in the horizontal front porch
•
Range: 0~1023
Horizontal Sync Width (URP75 / URP85 only)
•
The number of pixel clocks in the horizontal sync pulse
•
Range: 0~255
Vertical Blanking (URP75 / URP85 only)
•
The number of non-active lines in a field
•
Range: 0~255
Vertical Front Porch (URP75 / URP85 only)
•
The number of line times in the vertical front porch
•
Range: 0~255
Vertical Sync Width (URP75 / URP85 only)
•
The number of line times in the vertical sync
•
Range: 0~255
Revert to Factory
•
Reset the EDID type and timings to the default values for the selected connector
Planar UltraRes P Series User Manual
020-1407-01B
55
Page | 55