Add Reader - Interlogix ACL800SUW-BSPX Installation Manual

Biometric swipe proximity reader
Table of Contents

Advertisement

RS485 tuning
Figure 4: RS485 tuning
Terminate both ends of the line with 120 Ohm resistor
If the communication is not established and stable, use the
external resistors provided in the hardware kit.
Enrollment
Figure 5: Enrollment
Follow the below instructions for correct finger swiping starting
from the first finger joint, place the selected finger on the swipe
sensor and move it evenly towards oneself in one steady
movement.
Result:
For a valid swipe: Tricolour Status LED turns green + OK beep
(short +long beep)
For an invalid or misread swipe: Tricolour Status LED turns red
+ error beep ( 3 short beeps)
Configuring the biometric readers in
ACL800 BioManager
ACL800 BioManager is software for fingerprint management of
Biometric readers, when used with third party access
controllers.
Main functions:
o
Fingerprint enrollment
It can be done by ANY biometric reader in the network or by
desktop (USB) biometric reader
o
Fingerprint transfer
Finger templates can be sent to any reader in the network.
Different users can be sent to different biometric readers
o
Wiegand output Configuration
The Wiegand output of the Biometric reader can be
customized bitwise
Add Portal
Right-click on "Portals" and select "Add Portal".
P/N 1073507A• REV 00.00 • ISS 4JUL18
If the converter used for the biometric readers is RS485 to
TCP/IP, then create a portal by adding the IP Address of the
converter. (Figure 5)
Figure 6: Add Portal
Note: The portal can be added automatically with the "Search"
function.

Add Reader

Right-click on the portal connected to the reader and
select "Add Reader"
Select the type of the reader and fill the reader form. Put
the serial number of the biometric reader. The serial number is
written on the back side of the reader, but also can be
searched from the software
3 / 8

Advertisement

Table of Contents
loading

Table of Contents