Clarion MAX385VD Owners & Installation Manual page 19

Basic Operations
• Adjusting the non fader output
phase
You can adjust the subwoofer phase from the
SETTING adjustment menu.
1. Touch the ASP tab in the SETTING menu.
2. Touch the [SUB PHASE] button in the ASP
menu and a selection menu will appear.
Setting range:
o
or 180 (The factory default setting is "0")
Adjusting the non fader output
Low Pass Crossover
You can adjust the subwoofer phase from the
SETTING adjustment menu.
1. Touch the ASP tab in the SETTING menu.
2. Touch the [SUB FILTER] button in the ASP
menu and a selection menu will appear.
Setting range:
80,120 or 160Hz (The default setting is "60")
Adjusting the non fader output
volume
You can adjust the volume output from the unit's
Audio adjustment menu.
1. Touch the [-] or [+] key of the SW VOL item
to adjust to desirable level.
Setting range:
-7 to 7 (The factory default setting is "0".)
Turning on/off the LOUDNESS
The Loudness setting emphasizes the low and
high sound level areas to provide a more full and
dynamic sound without distortion.
1. Enter the Audio settings menu.
2. Touch [ON] or [OFF] of the [LOUDNESS]
item to turn on or off the loudness effect.
(The factory default setting is "OFF").
Adjusting the MONITOR
1. Press the [PIC] button on the remote control
or [MONI/ADJ] button on the MAX385VD.
2. Perform the adjustment for the desired item.
See the following sections for detail.
3. Touch the [Back] key to return to the previous
screen.
* In the following sections, only the details
regarding adjustments are described,
procedures to select items are skipped.
19
VRX485VD/MAX385VD
Adjusting the brightness, contrast
and color levels
1. Touch the [PIC] key on the remote control
or [MONI/ADJ] key on the MAX385VD.
2. Touch the [-] or [+] key to make adjustments
to the settings to your desired levels.
"Bright":
Adjusts the brightness of the display.
"Color":
Adjusts the color saturation.
"Contrast":
Adjusts the level of black.
or green is emphasized).
Bright/Color/Contrast:
The factory default setting is medium level.
Adjusting the SETTING
1. Press the [MENU] button, then touch the
[SETTING] key.
2. Touch the top navigation tabs to switch
between the SETTING menus. You can
navigate between General, Screen, ASP,
Regional, and Rating.
3. Perform the adjustment for the desired item.
See the following sections for detail.
4. Touch the [Back] key to return to the previous
screen.
* In the following sections, only the details
regarding adjustments are described,
procedures to select items are skipped.