Clarion MAX385VD Owners & Installation Manual page 42

6. CAUTIONS ON WIRING
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3. If the fuse should blow, check to see if the
wiring is correct.
If a fuse is blown, replace it with a new one of
the same amperage rating as the original
(15A FUSE).
4. To replace the fuse, remove the old fuse of
the power supply cord and insert the new one.
(Figure 8)
Note:
• There are various types of fuse holder. Do not let
the battery side touch other metal parts.
ACAUTION .
After the connection, fix the cord by a clamp
or insulation tape for protection.
Fuse holder
Fuse (15A FUSE)
Figure 8
VRX485VO/MAX385VD
42