Troubleshooting Zsim - Intermec EasyCoder PD41 Programmer's Manual

^ID, ^IL, ^IM, ^IS
^JA, ^JC, ^JG, ^JL, ^JM, ^JP, ^JR, ^JU, ^JX, ^JZ
^LH, ^LL, ^LR, ^LS, ^LT
^MC, ^MD, ^MF, ^ML, ^MM, ^MN, ^MT, ^MU
^PH, ^PF, ^PO, ^PM, ^PQ, ^PR, ^PW
^SD, ^SN, ^SS, ^ST
^WC
^XA, ^XF, ^XG, ^XZ

Troubleshooting ZSim

If you have issues with the ZSim program on your printer, look
for the symptom in the next table and then try the suggested
solutions.
Issues and Solutions
Issue
You change a value
in the Configuration
menu but the new
setting does not take
effect.
You manually set the
Print Mode to Tear
Off, but once you
send a label to the
printer the setting
reverts to Rewind.
ZSim Programmer's Guide
Solution
Press Enter or
If you press F2, Esc, or
canceled and the value of the setting is not
changed.
Check your print driver for its printer settings
and correct the Print Mode values. Some drivers
send down setup commands with their labels.
to save your changes.
, the changes are
35