Redo Config; Reset Tuning; Save Current; Select Character Set - Intermec EasyCoder PD41 Programmer's Manual

Redo Config

Purpose:

Reset Tuning

Purpose:

Save Current

Purpose:

Select Character Set

Purpose:

Simulation Resolution

Purpose:
Default:
ZSim Programmer's Guide
Removes the configuration file and reboots the
printer. The ZSim Initial Setup Configuration
Menu appears when the printer restarts. This
command requires access to the Fingerprint
Setup menu. You will be prompted to enter the
Fingerprint password before you can access this
command.
Returns all Media Tuning parameters to their
original (default) values.
Saves the current ZSim configuration
parameters for future use.
Allows the user to block any ^CIa (change
international font) command from host. For
example, if you enter 1257 (Windows Baltic
Rim), the corresponding character set will be
valid whichever international font is
downloaded. If you Clear the field, ZSim will
parse the ^CI command again.
Sets the resolution of the Zebra printer being
simulated. You can set this command to 152
dpi, 203 dpi, or 300 dpi.
Note: Differences in resolution may cause
degradation of bar code quality. See
Bar Code Magnification" on page 29
information on adjusting the resolution.
203 dpi (with 203 dpi printhead)
300 dpi (with 300 dpi printhead)
"Optimize
for more
31