Clear Permanent; Default Start Adjust; Default Stop Adjust - Intermec EasyCoder PD41 Programmer's Manual

Keys:

Clear Permanent

Purpose:

Default Start Adjust

Purpose:
Default:

Default Stop Adjust

Purpose:
Default:
26
EasyCoder printers:
F2 decreases value of Y-position
F3 increases value of Y-position
PB50 printers:
increases value of Y-position
decreases value of Y-position
Erases all formats and images stored in the
permanent memory of the printer.
Moves the origin towards or away from the edge
of the label by a certain distance before printing
starts. A positive start adjustment means that
the specified length of media will be fed out
before printing starts. A negative start
adjustment means that the specified length of
media will be pulled back before printing starts.
Printer Model
PF2/4i, PM4i
PX4/6i
PD41
PB50
Determines how much media feeds through
after printing is completed. This setting is used
to make sure that the labels are in the correct
position for tear off operation. This value can be
either positive or negative and is measured in
dots. A positive stop adjustment means that the
normal media feed is increased by the specified
value. A negative stop adjustment means that
the normal media feed is decreased by the
specified value.
0 dots (no adjustment)
Start Adjust (dots)
-100
-133
-80
0
ZSim Programmer's Guide