Printing A Label; Intermec Interdriver; Intermec Labelshop; Easycoder E4 Direct Protocol - Intermec EasyCoder E4 Installation And Operation Manual

Printing a Label

Intermec InterDriver

Intermec LabelShop

EasyCoder E4 Direct
Protocol
Intermec EasyCoder E4 – Installation & Operation Ed. 2
You can print labels using the Intermec InterDriver, Intermec
LabelShop, or the EasyCoder E4 Direct Protocol programming
language.
If you are using the Intermec InterDriver for the EasyCoder E4:
• Design a label in, for example, MS Office or Intermec
LabelShop.
• Enter the number of copies required in the InterDriver
application.
• Send the label to print.
If you are using some version of Intermec LabelShop:
• Follow the instructions in the manual for the version of LabelShop
installed in your PC.
If you are using EasyCoder E4 Direct Protocol, there are two ways
to prepare and print a label. These methods allow the EasyCoder
E4 also to be used with other operating systems than Microsoft
Windows and NT.
• Type instructions in the Direct Protocol programming language
into a terminal program, which sends them to the printer one
instruction at a time. To print a label, send a PRINTFEED
command.
• Type instructions in the Direct Protocol programming language
into a text editor and send the resulting text fi le to the printer
using DOS Copy or a terminal program. If you include a
PRINTFEED command in your fi le, the printer will print
the label immediately.
You can tell the printer how many copies you want by adding a number
to the PRINTFEED command, for example PRINTFEED 22.
When you have sent a label to the printer, it will be printed out
whenever you send a PRINTFEED command. If you switch off
the printer or send any command starting a new label, the previous
label format will be lost.
If you have enabled the Feed button to work as a print button using
a PRINT KEY ON command, a new copy of the label presently
stored in the image buffer will be printed each time you press
the Feed button.
See Appendix 4, "Programming" or the EasyCoder E4 Direct
Protocol, Programmer's Guide for further information.
Chapter 3 Operation
23