Intermec EasyCoder 3400 User Manual page 57

Printer Operation Problems (continued)
Symptom
Printer slows down.
Labels stick to door or fail
to strip.
The Alert LED flashes and
printing stops.
Media fault.
Test configuration label
does not print.
Printer is not
communicating, not
printing, or not printing
properly.
3400, 3440, and 3600 Bar Code Label Printer User's Manual
Possible Causes
The image bands or print speed is
incorrectly set.
The printer has aborted and reset the
print speed and image bands.
The self-strip roller is dirty.
Printhead has overheated.
The printhead is up.
Sensor type set incorrectly.
The media is incorrectly loaded.
The media is incorrectly loaded.
The printer is configured for self-strip
media.
Media fault.
Corrupt or incorrect information in
printer memory.
Chapter 4— Troubleshooting
Solution
Use PrintSet to change the image bands or
print speed settings.
Use PrintSet to change the image bands or
print speed settings.
Clean the self-strip roller. See Chapter 3,
"Maintaining the Printer."
Leave printer alone until it has time to cool
down. It will resume printing on its own.
Make sure the printhead is down. The head
lift lever should be straight up and down.
Press the Feed/Pause button to resume
printing.
Configure the printer for the correct sensor
for the Print mode you are using. You can
enable self-strip and other Print modes
from PrintSet.
Try reloading the media. For help, see
"Loading Media Into the Printer" on page
18.
Try reloading the media. For help, see
"Loading Media Into the Printer" on page
18.
Set the printer to the default configuration
using the DIP switches. For help, see
"Plugging In the Printer" on page 4.
Remove media from under the label taken
sensor.
Reset the memory to return the printer to
its default configuration. For help, see
"Resetting the Memory on Your Printer"
on page 59. After you reset the memory,
power off the printer and return the DIP
switches to the required setting. For help,
see "Configuring the Serial Port for
Communications" on page 11.
43