Intermec EasyCoder 301 Accessory Installation Manual
Paper cutter kit
Hide thumbs
Also See for EasyCoder 301:
- Programmer's manual (113 pages) ,
- Service manual (83 pages) ,
- Installation and operation manual (41 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Intermec EasyCoder 301
Summary of Contents for Intermec EasyCoder 301
- Page 1 Installation Instructions P/N 1-960457-00 Edition 1 April 1999 EasyCoder 301 Paper Cutter Kit...
- Page 2 Part No. 1-960457-00 Intermec EasyCoder 301 Paper Cutter– Installation Instructions Ed. 1 The EasyCoder 301 can easily be fitted with an optional Paper Cutter. The cutter unit is fitted on the same hinges as the front door, which it replaces, and is connected by a single cable to the upper-most connector on the printer's front.
-
Page 3: Controlling The Cutter
Installation Hinges Front Cover (open) Intermec EasyCoder 301 Paper Cutter– Installation Instructions Ed. 1 The cutter is activated by CUT or CUT ON instructions in the EasyCoder 301 Direct Protocol. The following values are recommended for cutting between labels and for variable length strip. In both cases, the start adjustment is calculated to allow the paper web be pulled back after cutting, so printing can start directly at the forward edge. - Page 4 Installation, cont'd. Intermec EasyCoder 301 Paper Cutter– Installation Instructions Ed. 1 • Fit the two hooks at the rear of the cutter unit on either side of the tear off edge and press down firmly. • The holes in the tabs at the bottom of the cutter unit should be aligned with the hinges on the bottom moulding.
- Page 5 Information in this manual is subject to change without prior notice and does not represent a commitment on the part of Intermec Printer AB. © Copyright Intermec Printer AB 1999. All rights reserved. Published in Sweden. EasyCoder is a trademark of Intermec Technologies Corp.