Intermec EasyCoder 3400 User Manual page 74

Chapter 6— Using Test and Service Mode
60
To use memory reset
1 Turn the printer off.
2 Press and hold the Feed/Pause button while turning on the printer. The
printer prints a hardware configuration test label.
3 Set the DIP switches to reset a portion or all of the memory by using
the Test and Service Mode DIP Switch Settings table on page 57.
4 Hold the Feed/Pause button down for 1 second. The printer resets a
portion or all of its memory.
5 To exit Test and Service mode, turn the printer power off and then on.
If you have a 3400C printer, you can also reset the entire memory on
the printer. This procedure is identical to resetting the memory by
removing the battery.
To reset the entire memory on the 3400C printer
1 Turn the printer off.
Note: You must turn off the printer before pressing the memory reset
button or the printer may not operate correctly.
2 Using a small screwdriver, press the memory reset button for 30
seconds. The printer resets the entire memory.
O
3XXXU.042
3 Turn the printer on.
3400, 3440, and 3600 Bar Code Label Printer User's Manual
I
O
I O