Using The Feed/Pause Button - Intermec EasyCoder 3400 User Manual

C d
Green LED
Orange LED
Yellow LED

Using the Feed/Pause Button

3400, 3440, and 3600 Bar Code Label Printer User's Manual
39
Helvetica Condensed Helvetica
Power/Data
Alert
Empty/Pause
Feed/Pause
LED states: This illustration shows what each LED state indicates.
Note: The green LED on the 3600 printer front panel reads Power. It
does not flash to indicate receiving data.
LED States for Problems
Problem LED State
Over-Temperature If the printer overheats, the Alert flashes and the printer stops. Do
not try to troubleshoot or adjust the printer—just allow the printer
enough time to cool down and it will resume operation on its own.
Media or System If the Empty/Pause or the Alert LED remains on, your printer is
Faults experiencing a media or system fault. For help, see Chapter 4,
"Troubleshooting."
The Feed/Pause button, located on the front of the printer, performs
several functions depending on the mode of the printer.
Feed/Pause Button Functions
Printer
Mode You Want To
Idle Feed out one label or
a minimum specified
amount of media.
Continuously feed
media.
Take the printer
offline.
Printing Pause the printer.
Cancel the current
print job.
Chapter 2— Operating the Printer
LED
Power/Data
Alert
Empty/Pause
3XXXU.025
What to Do
Press and release the Feed/Pause button.
Press and hold the Feed/Pause button. When
you release the button, the media stops feeding.
Press the Feed/Pause button twice. Press the
button again to bring the printer online.
Press and release the Feed/Pause button. Press
and release the button again to resume printing.
Press and hold the Feed/Pause button until the
printer stops printing.
State Indication
Off Power off
On Power on
Flashing Receiving data
Off Printing or idle
Flashing Over-temperature
On System fault
Off Printing or idle
Flashing Paused
On Media fault
17